TenTec
[Top] [All Lists]

Re: [TenTec] Paragon II Display problem HELP

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Paragon II Display problem HELP
From: <waltk8cv4612amos@att.net>
Reply-to: waltk8cv4612amos@att.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 20 Aug 2008 20:42:52 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Put a short wire from ground on the front panel board to the main board.

Walt K8CV Royal Oak, MI.

----- Original Message ----- 
From: <ARDUJENSKI@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, August 20, 2008 8:02 PM
Subject: [TenTec] Paragon II Display problem HELP


> PROBLEM: The Paragon II display board is set with a series of "7's" in its
> display
>
> I replaced the rocker ON/OFF switches on both the 961 PS and the PARAGON 
> II.
> I replaced the PS switch first and the units worked fine. Then I  decided 
> to
> replace the PARAGON II switch. I removed the top and bottom clamshell 
> covers
> then loosened the side screws for the front panel then slowly and 
> carefully
> rotated the front panel forward to gain access to the back of the  rocker
> switch. The base of the PARAGON II was propped  about 2 inches to  allow 
> free
> rotation of the front panel. The ON/OFF rocker switch was replaced 
> without
> incident and a check of all connectors was made to ensure they were all 
> seated and
> no wires pulled away.  When energizing the unit the DISPLAY  showed only a
> series of "7's" which did not change. I rotated the tuning knob  and a few 
> "7's"
> blinked but nothing else. I tried cycling off and on a few times  with 
> waiting
> period in between but no changes.
>
> The radio does receives.
>
> I went back a second time removing all the connectors on the front panel 
> and
> top boards and cleaned with DE-OXITE with a sprayed Q-Tip and reseated 
> them.
>
>
> TEN TEC: I did contact Ten Tec Service and was advised to check the
> connectors (which I did) and it not would would need to see some bench 
> time to  figure
> it out.
>
> Before I box this up for that trip to Ten Tec I was hoping someone else 
> may
> have experience this problem and has a solution. Is there some other tests 
> or
> checks or maybe a RESET?
>
> I appreciate your help.................Alan  KB7MBI
>
>
>
> **************It's only a deal if it's where you want to go. Find your 
> travel
> deal here.
> (http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>