TenTec
[Top] [All Lists]

Re: [TenTec] Orion RIT...

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion RIT...
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 7 Jul 2008 10:06:26 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
This is a very curious problem, and many of the posts we have seen here seem 
to indicate that it may have something to do with the through-plating on the 
double-sided circuit board.  Look very carefully at both sides of the 
circuit board where it's mounted using very bright light and a good 
magnifying glass or jeweler's loupe.

         Ron  N6IE
      www.N6IE.com


----- Original Message ----- 
From: "John T. Fleming" <W3GQJ@embarqmail.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Monday, July 07, 2008 9:35 AM
Subject: Re: [TenTec] Orion RIT...


> Roy,
>
> I have decided I am going beat this problem.  I am going to remove the 
> case
> from my Orion and remove the screws from the front panel.  Then I plan to
> put a board under the front of the chassis to tilt the display.  When the
> problem shows again, I am going to remove the front panel.  If the problem
> cures itself, I will start checking the ribbon cables.  If nothing is 
> cured,
> I am going to start probing around the encoder board with a plastic tool 
> and
> see if I can find the problem.  If that fails, I will try to "cold" spray
> and see if that shows the source of the problem.  I will either be having 
> a
> glass of champagne in celebration or crying in my beer with frustration! 
> :=}
>
> 73,
> John
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Roy
> Sent: Monday, July 07, 2008 12:19 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Orion RIT...
>
> "For those who have experienced this.... what were your resolutions?"
>
>
> Snap it hard with your finger.
>
> 73,  Roy   K6XK
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>