John -
Please keep us posted on your successes. I guess, non-successes, also.
73 de K1ESE
John
John T. Fleming wrote:
> Roy,
>
> I have decided I am going beat this problem. I am going to remove the case
> from my Orion and remove the screws from the front panel. Then I plan to
> put a board under the front of the chassis to tilt the display. When the
> problem shows again, I am going to remove the front panel. If the problem
> cures itself, I will start checking the ribbon cables. If nothing is cured,
> I am going to start probing around the encoder board with a plastic tool and
> see if I can find the problem. If that fails, I will try to "cold" spray
> and see if that shows the source of the problem. I will either be having a
> glass of champagne in celebration or crying in my beer with frustration! :=}
>
> 73,
> John
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Roy
> Sent: Monday, July 07, 2008 12:19 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Orion RIT...
>
> "For those who have experienced this.... what were your resolutions?"
>
>
> Snap it hard with your finger.
>
> 73, Roy K6XK
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|