On Wed, 2008-05-07 at 07:53 -0400, Bill Ames wrote:
> Well, that is a good question. I do have one of those MFJ meters and I will
> measure it at the feedpoint. However I think the antenna resonates around
> 2.8 MHz. I think I will have to adjust some lengths and heights. It has been
> up for ten years or so and feeding it with a 100 W it worked just fine.
And if you match it the same with a low loss tuner, it will work just
fine for QRP. The longer length should give you some gain over an 80
meter resonant dipole.
> But
> using it QRP I need to get it just right. If I had just a, say, 150 ohm Z
> (no reactive components), could I just use a torrid transformer to match the
> rigs 50ohm output?
You could, but any antenna with much bandwidth at constant impedance
(except my broad band 80 meter dipole), will have reactance, and I think
the tuner would probably have lower losses than the toroid unless the
toroid was large (like on a T240 core).
>
> Bill
> KB1LG
>
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|