I run my mike gain at 50 and the H/W MIC Gain at 6.0 DB with the 708 mike.
I have a 705 mike for the Jupiter but don't have an adapter handy for the
Orion II. I have used the 708 on the Jupiter satisfactorily. I have
another 708 for the Omni VII, I can switch with no adjustments necessary.
----- Original Message -----
From: "Dennis Bryant" <brya5984@bellsouth.net>
To: <tentec@contesting.com>
Sent: Monday, May 05, 2008 4:20 PM
Subject: [TenTec] 708A MIC setting
> Good afternoon all,
>
>
>
> As many of you heard yesterday on the TenTec net, I have a question about
> my 708A microphone used with my Orion II.
>
> I have to set the mic gain at 70 on 20 meters and 90 on 10 meters in order
> to get the red ALC light to twinkle and them only with my mouth on the
> mic. The manual suggested setting is 60.
>
> My 706 makes the ALC blink at a mic setting of 40 on all bands. I have
> over 30 years of acting experience in amateur theater so I don't have a
> problem with projecting my voice.
>
> I do know there is an internal mic gain (it was set at 2.0 and I increased
> it to 2.5). I am a little leery of using that gain too much because of the
> warning in the manual.
>
> Does anyone have a suggestion before I contact TenTec?
>
>
>
>
>
> Dennis, N4MUS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|