There was a particular encoder that Ten Tec used for a while that wasn't of the
best quality. I've had to replace my main tuning encoder. The Ten Tec parts
department carries a replacement encoder.
Regards, Thomas - AC7A
---- Doug <w5ga@arrl.net> wrote:
> When I spin the tuning knob on my O-6, the frequency doesn't change. RIT
> works fine, and keypad entry works fine also. Should I be looking for a new
> encoder, or could it be something else?
>
> 73, Doug W5GA
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|