May be a loose connector behind the faceplate where the encoder talks
to the processor, I'd check that first. You can test your own encoder
by switching the connector from the RIT control over to the main
tuning, they should do about the same thing. If the RIT control works
to change your frequency while the main encoder fails, you have the
answer :-) Been there.
Clark
WA3JPG
On Apr 13, 2008, at 6:06 AM, Doug wrote:
> When I spin the tuning knob on my O-6, the frequency doesn't change.
> RIT
> works fine, and keypad entry works fine also. Should I be looking for
> a new
> encoder, or could it be something else?
>
> 73, Doug W5GA
>
Clark Savage Turner, J.D., Ph.D.
Professor of Computer Science
Cal Poly State University
San Luis Obispo, CA. 93407
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|