Not only that, but adjacent splatter went away as well.
Bob
----- Original Message -----
From: "Gary Hoffman" <ghoffman@spacetech.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, March 23, 2008 8:06 PM
Subject: Re: [TenTec] New rubber trim pieces for TT knobs....
> When I mounted my Ten Tec license plate on my shack wall, the signal to
> noise ratio of all of my receivers improved by almost 10 dB.
>
> 73 de Gary, AA2IZ
>
>
> ----- Original Message -----
> From: "John Huffman" <hjohnc@gmail.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Sunday, March 23, 2008 8:50 PM
> Subject: Re: [TenTec] New rubber trim pieces for TT knobs....
>
>
>> These trim rings are cool. I assume the goal is to match the ring color
>> to the color of the Ten Tec dot :-)
>>
>> 73 de K1ESE
>> John
>>
>> fraz1 wrote:
>> > I tried to resist spending 10 bucks a piece for the new rubber trim
> pieces offered for the later TT equipment. But, the "kid" in me won out.
> They actually look and fell very nice on my Orion. Glad I did it. While
> I
> was at it...got the darn coffee cup too; nice to have.
>> >
>> > If all Orion owners buy the new knob trim pieces, maybe we can get some
> additional firmware work done? They are shown on the TT web site.
>> >
>> > Oh, and yes, they improved the BDR , IMD and NR on my Orion ;-).
>> >
>> > 73 John K4NP
>> > _______________________________________________
>> > TenTec mailing list
>> > TenTec@contesting.com
>> > http://lists.contesting.com/mailman/listinfo/tentec
>> >
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|