Are you running the 705 by battery or through the Omni V? If through the
Omni V, check the voltage at the jack first. If by battery, check the
battery. Then check the plug before going inside it.
Good luck,
David
----- Original Message -----
From: "Greg Kuczek" <gjk1406@verizon.net>
To: <tentec@contesting.com>
Sent: Sunday, February 03, 2008 10:23 PM
Subject: [TenTec] 705 Mic Low Output Help Request
>I have a 705 mic that I am having low output problems when used with an
>Omni V. I've read that you can change out the R11 resisitor to 3300 ohms to
>help correct this. Unfortunately I don't have a schematic or any
>documentation to help me locate this resistor. Any help identifying R11
>would be appreciated.
>
> 73 de Greg W9VOX
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|