Use the KEY jack. Closing the "DA" connection, TIP/SLEEVE, puts the radio
in transmit in the USB or LSB mode. No connection to the MIKE jack needed
for PTT.
73
Bob, K4TAX
----- Original Message -----
From: "Ernie Piche N1SW" <n1sw@cox.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, November 20, 2007 7:35 PM
Subject: [TenTec] OMNI VII and Heil Pro Headset.
>I was fortunate last Christmas to received a Heil Pro headset which is
> very nice. Heres the problem! I attempted to use it on the OMNI VII
> only to find out that I can't use the PTT cable with the rig. As soon
> as you plug the PTT cable into the radio it goes into transmit. OK,
> before anyone asks, yes I have checked the wiring! I had to build an
> interface cable so I could use the mic/headset with the omni mic
> connector. I have tried various configurations of connections for the
> ground leads and still no success. Soooooooooooo I had to make an
> external PTT switch connection to the mic jack and it works fine. Also
> my D 104 works fine.
>
> Before I contact Heil, has anyone else had this situation come up?
>
> Thanks
> 73 Ernie
> N1SW
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|