Exactly, In fact there are a couple things wrong with what he said.To start
with many SS rigs have a mic input impedances in the hundreds of ohms , or a
few K at most,not 100K's Short of it is connecting it to a rig with a lower
input Z tends to flatten out the response, so you probably end up with a
pretty decent SSB mic as well as a terrific AM mic when operated into hgh Z.
In fact some of the old crystal mics had a response control, which was
nothing more than a switch for a shunt resistor.
W6RD
----- Original Message -----
From: "N4NT" <mike_n4nt@embarqmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, November 16, 2007 12:13 PM
Subject: Re: [TenTec] Using a comptuer microphone with a Triton 4 (544)
> This is absolutely untrue in my experience. I have compared microphones
> on
> the Triton 544 and ALWAYS the listeners prefer the D-104. Folks who know
> me
> in person say the D-104 has the best representation of my voice. Based on
> my experience, the D-104 is FAR from being a crappy microphone!
>
> 73, Mike N4NT
>
> ----- Original Message -----
> From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
> To: <tentec@contesting.com>
> Sent: Friday, November 16, 2007 11:36 AM
> Subject: Re: [TenTec] Using a comptuer microphone with a Triton 4 (544)
>>
>> The D-104 is a crappy microphone for SSB, always has been. It has a
>> rising characteristic intended (in the 30s) to emphasize the highs at
>> the transmitter that were rolled off in the typical AM receiver IF
>> selectivity that had a very rounded pass band. Further the crystal and
>> ceramic D-104 were designed to work with a very high impedance load for
>> solid state, preferred load a megohm. Today a high impedance solid state
>> audio input impedances is likely to be under 100K. That load on a D-104
>> changes it from rising to peaked and falling, makes it sound muffled. It
>> it still had the rising characteristic with the solid state input Z, it
>> can overdrive audio and balanced modulator with audio components
>> rejected by the SSB filter unless in super wide SSB mode which draws a
>> lot of fire on the bands.
>>
>> Yes, I have a D-104 (case) hooked to my Corsair II. The cartridge is a
>> Shure limited bandwidth communications element no longer made.
>>
>> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|