On Thu, 2007-10-18 at 09:31 -0400, Louis Ciotti wrote:
> Well last night I losened two of the four screwes and re tightened them on
> the suspect board, and that did not work. I could not get at the remaining
> two with out a lot of dissassembly. Seeing how this is my only HF rig and
> with not a lot of time I did not want to dig further into the preblem.
>
> I did tap around a bit and found another area where the problem comes and
> goes. I completely removed that baord, reseated it and the problem persists.
>
> So as of now I still have an intermitant transmit problem. I also noticed
> last night that it sometimes "partially" transmits. For example, I was
> tuning up on 20 meters, and with known good setting on the tuner, I was not
> getting full output power. A tap in the right spot and bingo full power.
> Any more thoughts on what the problem could be?
>
> Thanks,
>
> Lou
> KC2RVD
>
Bad solder connection on that PC board. Could be totally missing solder.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|