| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] reduce RF Gain on a Scout? |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 3 Oct 2007 22:12:29 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
A couple of us considered doing the mod and mounting the pot on an angle bracket which could be fastened to existing hardware on the Scout. However, I personally put off doing it, and got the Argonaut V. There is enough of a gap between the case and the heat sink to work a flat cable thru there to the back panel area. -Stuart K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] reduce RF Gain on a Scout?, Stuart Rohre |
|---|---|
| Next by Date: | Re: [TenTec] Omni VII Question, Gary Hoffman |
| Previous by Thread: | Re: [TenTec] reduce RF Gain on a Scout?, Ken N9VV |
| Next by Thread: | Re: [TenTec] reduce RF Gain on a Scout?, ron |
| Indexes: | [Date] [Thread] [Top] [All Lists] |