TenTec
[Top] [All Lists]

Re: [TenTec] (Orion) firmware update with serial port-less computer

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] (Orion) firmware update with serial port-less computer
From: "Jim Cox" <jcox123@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 21 May 2007 07:16:36 -0500
List-post: <mailto:tentec@contesting.com>
Byterunner also sells a USB to 4 port serial, very reasonable. I use one here and have had no problems with it. Jim K4JAF


----- Original Message ----- From: "Robert Carroll" <w2wg@comcast.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Monday, May 21, 2007 7:09 AM
Subject: Re: [TenTec] (Orion) firmware update with serial port-less computer


What I have done several times is to look on ebay for a used rocketport PCI
card.  These are UART based and designed for commercial POS applications.
You will find 8 port versions with an external cable.  There are DB9 and
DB25 cable versions. You will also find cards with no cables. Don't go for those as the cables by themselves are hard and expensive to find. Microsoft XP includes a certified driver for the Rocketport boards. You can find one used for $25-$50. New ones are available too on ebay for around $300. You
may have to look for a week or two to find a used one. Make sure you don't
get one for an older ISA type bus--unless you are using an antique computer.

73
Bob W2WG

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of George
Sent: Monday, May 21, 2007 7:51 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] (Orion) firmware update with serial port-less computer

I just bought a new mother board at Dayton. I knew that it did not have any
COM ports. I need 4 com ports to run my hamshack, O2, rotor, packet, etc.
What is the best way to get 4 com ports, board or 4 individual USB to com
converters? If I go with the individual converters I'll need a USB expansion

board.
Suggestions?
Thanks.
George  W2YJ


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>