Not yet. I should have around it handling the audio around May 1.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Alan Sewell" <alan.n5na@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, April 20, 2007 11:33 PM
Subject: Re: [TenTec] Slaving radios
> Carl,
>
> Is your Omni VII program handling the audio over the ethernet connection
> now? The last I heard you were working on it.
>
> 73,
>
> Alan N5NA
>
> http://www.tentecwiki.org
>
>
>
> Carl Moreschi wrote:
> > You can do it several ways. If the O7 is near your computer, you can
just
> > connect a serial port from the computer to the O7. I think the limit on
a
> > serial cable is about 50 feet. If the O7 is 1200 feet from the shack,
you
> > can run an ethernet cable from the computer to the O7. My N4PY software
> > will then control the radio very nicely. My webpage is at www.n4py.com
> >
> >
> > Carl Moreschi N4PY
> > 121 Little Bell Drive
> > Bell Mountain
> > Hays, NC 28635
> >
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|