Carl,
Does this require the use of an Internet connection, or directly?
Larry, W0PR
----- Original Message -----
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, April 20, 2007 8:36 AM
Subject: Re: [TenTec] Slaving radios
> You cannot slave the 2 radios together like you can with Icom radios. But
> you can control the Omni VII perfectly from a computer via the serial port
> or ethernet port. I have software for this.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message -----
> From: "Larry Menzel" <retire@means.net>
> To: <TenTec@yahoogroups.com>; "Discussion of Ten-Tec Equipment"
> <tentec@contesting.com>
> Sent: Friday, April 20, 2007 9:29 AM
> Subject: [TenTec] Slaving radios
>
>
>> Good morning all,
>>
>> Does anyone know if the new Omni VII with all its features and control
> stuff can allow two of them to be slaved together...so that anything done
> by
> one will echo on the other via CAT5 cable or some other means?
>>
>> Or does it just work via control software and the internet? A friend of
> mine would like to know. He would trench the cable about 1200 feet if
> it'll
> work.
>>
>>
>>
>> Larry, W0PR
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|