TenTec
[Top] [All Lists]

Re: [TenTec] Orion default BW by mode

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion default BW by mode
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 25 Mar 2007 20:21:42 -0400
List-post: <mailto:tentec@contesting.com>
I must point out that my N4PY Orion software solves all these BW issues with
spotting software.  My software can run along with any logging or DX spoting
software that supports the tentec file interface.  You just configure the
spotting or logging software for a tentec pegasus.  And you have the option
of either running my software in polling mode which allows you to operate
the Orion from its front panel, or run my software without polling mode and
operate the Orion entirely from my program.

Also, most logging and DX spotting software will run in conjunction with my
software but I also have  DXSpots and logging software that is free to all
registered users of my radio control programs.

And by the way, I just had a price reduction on my N4PY Orion Control
Program.  See my webpage at www.n4py.com

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Martin AA6E" <aa6e@ewing.homedns.org>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, March 24, 2007 6:08 PM
Subject: Re: [TenTec] Orion default BW by mode


> I suggest you check your Menu > RX > PBT Track and BW track.  You should
> set these to OFF unless you know you want that behavior.  I assume you
> are not using your bandstacking regs? They will change your BW depending
> on what your settings were when a particular reg was loaded. (I don't
> like the BS regs as they are implemented.)
>
> 73 Martin AA6E
>
> Barry N1EU wrote:
> > This issue might have been discussed previously, but perhaps someone can
> > refresh my memory.
> >
> > When I change my Orion's mode from USB to LSB or vice versa, I see the
BW
> > jump from 2400hz to 6000hz.  Why?  Is the Orion recalling some default
> > setting stored somewhere?  Has anyone figured this out?  Can I somehow
> > change that setting?
> >
> > I'm running v1.373b5 firmware, but I seem to remember v2.059d behaving
> > similarly (I might be wrong because every time I try v2.059d, I soon run
> > back to v1.373b5).
> >
> > Thanks & 73,
> >
> > Barry N1EU
> > n1eu.com
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>