I suggest you check your Menu > RX > PBT Track and BW track. You should
set these to OFF unless you know you want that behavior. I assume you
are not using your bandstacking regs? They will change your BW depending
on what your settings were when a particular reg was loaded. (I don't
like the BS regs as they are implemented.)
73 Martin AA6E
Barry N1EU wrote:
> This issue might have been discussed previously, but perhaps someone can
> refresh my memory.
>
> When I change my Orion's mode from USB to LSB or vice versa, I see the BW
> jump from 2400hz to 6000hz. Why? Is the Orion recalling some default
> setting stored somewhere? Has anyone figured this out? Can I somehow
> change that setting?
>
> I'm running v1.373b5 firmware, but I seem to remember v2.059d behaving
> similarly (I might be wrong because every time I try v2.059d, I soon run
> back to v1.373b5).
>
> Thanks & 73,
>
> Barry N1EU
> n1eu.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|