It depends. Do you need a blanker, or DSP noise reduction? Or both? Both
work well (although there are different opinions on this). Frankly, the
only way to know for sure is to try it. The good thing about T-T is that
for the cost of shipping you get 30 days to test it and see if it meets your
needs.
Either the I or II is very good in this regard, but without trying it on
your specific noise, it's impossible to generalize.
Grant/NQ5T
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of Chris Brougham
> Sent: Tuesday, March 20, 2007 6:58 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] Orion Noise Reduction Ability
>
> Hi Folks,
>
> I'm considering a new rig to replace my Mark V. I live in an
> extremely
> noisy environment and have found the noise reduction
> capabilities of the
> Mark V lacking. I've used the MFJ noise reducer to phase out
> some of the
> crud, but I'm still not completely satisfied. Interestingly, my SGC
> 2020s ADSP II rig has a much better DSP solution and this leads me to
> believe maybe a more advanced DSP is the way to go.
>
> Can anyone comment on either the Orion I or Orion II's
> ability to defeat
> wide band power line noise?
>
> Thanks for any help!
>
> 73 Chris VA7CAB
>
> --
> Chris Brougham
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|