TenTec
[Top] [All Lists]

Re: [TenTec] Whats a good way to monitor your cw signal?

To: "Lee Armitage" <LEE@GJ.NET>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Whats a good way to monitor your cw signal?
From: "dw" <bw_dw@fastmail.fm>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 16 Mar 2007 19:21:52 -0700
List-post: <mailto:tentec@contesting.com>
Thank you Lee!!

I will try to find one for a good 30 meter listen.

Thanks! :)

On Wed, 14 Mar 2007 21:38:28 -0600, "Lee Armitage" <LEE@GJ.NET> said:
> www.smeter.net I believe is what you meant for ham radio S meter.
> 
> Thanks and 73,
> Lee Armitage N7FV
> 
> ----- Original Message ----- 
> From: "HUGHESRO" <ROGERH@realtracs.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Wednesday, March 14, 2007 9:30 PM
> Subject: Re: [TenTec] Whats a good way to monitor your cw signal?
> 
> 
> > Hello Duane. It's very easy and a real experience. Get your radio ready to 
> > transmitt. Then go to www.smeter.com. Pick out a reciever and Call Cq or 
> > something and listen to your signal. The radios are for the most part all 
> > out west. That is what they are for. Art Bell has one of the remote 
> > radios. Plus goobs of other stuff abt Ham Radio on web site. Tell us how 
> > it worked out. Roger W4IV  TN.
> > ---------- Original Message ----------------------------------
> > From: "JAMES HANLON" <knjhanlon@msn.com>
> > Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> > Date:  Wed, 14 Mar 2007 10:09:14 -0600
> >
> >>Duane,
> >>
> >>I am "blessed" with many old, "boatanchor" receivers, and I just use one 
> >>of them with the antenna terminals shorted and the RF gain turned down to 
> >>listen to myself.  Perhaps you could find something inexpensive and a bit 
> >>better than the S-38 level at a local hamfest or on the web that would do 
> >>the trick.
> >>
> >>Jim, W8KGI
> >>  ----- Original Message ----- 
> >>  From: dw<mailto:bw_dw@fastmail.fm>
> >>  To: Discussion of Ten-Tec Equipment<mailto:tentec@contesting.com>
> >>  Sent: Tuesday, March 13, 2007 7:55 PM
> >>  Subject: [TenTec] Whats a good way to monitor your cw signal?
> >>
> >>
> >>  My 25 amp power supply did a hick-up last week-end and since then I've
> >>  received
> >>  2 warble reports on 30.
> >>  No bad reports on other bands though.
> >>
> >>  I have a small hand-held icom RC-10 which has cw mode, and I listened to
> >>  myself on all bands with it the other day, but I'm not sure if I can
> >>  hear the warble or not.
> >>
> >>  Running the Jupiter.
> >>
> >>  On one report, I pulled the power down to 75% and was told it was still
> >>  there.
> >>
> >>  Your suggestions highly appreciated.
> >>
> >>  Tnx
> >>  Duane
> >>  N1BBR
> >>  -- 
> >>    dw
> >>    dw@sover.net<mailto:dw@sover.net>
> >>
> >>
> >>_______________________________________________
> >>TenTec mailing list
> >>TenTec@contesting.com
> >>http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> > 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
-- 
  dw
  dw@sover.net

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>