| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] ALC control |
| From: | "George Osier" <gosier@twcny.rr.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 10 Mar 2007 16:25:28 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Just a bit of help here needed........... To run a Omni A at QRP levels I realize turning down the drive will bring the power down but I'm not so sure about the use of the ALC control ???? Thanks !!! George , N2JNZ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] How to K2 and Paragon compare?, Paul |
|---|---|
| Next by Date: | Re: [TenTec] ALC control, Clark Savage Turner |
| Previous by Thread: | [TenTec] AM BCB Sensitivity on Omni VII?, NZ8J |
| Next by Thread: | Re: [TenTec] ALC control, Clark Savage Turner |
| Indexes: | [Date] [Thread] [Top] [All Lists] |