Excellent Carl !
I'm gonna keep asking about the Ethernet aspects of the rig. Any insights
there yet >
Gary, AA2IZ
----- Original Message -----
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, March 08, 2007 11:34 AM
Subject: Re: [TenTec] OmniVII band output info??
> There are no band outputs on the back of the Omni VII. Computer control
is
> the answer. My N4PY software will have full function for this.
>
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, North Carolina 28635
>
> ----- Original Message -----
> From: <k7gt@charter.net>
> To: <tentec@contesting.com>
> Sent: Thursday, March 08, 2007 11:22 AM
> Subject: [TenTec] OmniVII band output info??
>
>
> > Hi gang,
> >
> > A question for those with OmniVIIs. I reviewed briefly the OmniVII
manual
> that is
> > on-line and couldn't locate an output for band information. Both the
> OmniVI and Orion
> > have that info available on the back panel (so did the Corsair I and
some
> earlier rigs).
> > Has this very useful feature been dropped or does one have to go through
> computer
> > control to get that info?
> >
> > Otherwise it looks like the VII may be in my future.
> >
> > Allan K7GT
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|