How can I lower the drive to the finals on an original Orion so that
I can run less than 5 watts. Even with the "PWR" turned down all
the way, I cannot get below about 7 watts on some bands.
I'm loathe to continue to use an attenuator to assure QRP power
levels.
I am not concerned if this limits the max power with the "PWR"
turned up fully. I'm using the ver 1.372 software.
On CW, with the "PWR" set above 70 or so, the meter needle bangs
against the right hand stop when keying. Any fix for this?
72,
Tim
________________________________________________________________________
Interested in getting caught up on today's news?
Click here to checkout USA TODAY Headlines.
http://track.juno.com/s/lc?s=198954&u=http://www.usatoday.com/news/front.htm?csp=24
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|