On Fri, 2007-02-16 at 07:20 -0800, Paul wrote:
> I've run my ArgoV on digital modes and I'm sure a fan is necessary
> because I am running near full power - 20 watts. I'm thinking of
> setting up a Pegasus as the main digital rig but my power level
> relative to what the Pegasus would put out is much lower. That is,
> except for CW, I'd be running it between 40 and 50 watts. At that
> power level, would I/should I get the Ten Tec fan for the Pegasus?
I ran the Pegasus in the RTTY Roundup earlier this year. I was only
running about 30w and started out with no fan, but I noticed that the
heatsink was getting too hot to touch so I attached the TenTec fan that
I had, after that no problem, so I would say, use a fan.
73,
Mark
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|