Our club has an Omni6+, a fairly old model with option 3. I've nulled the
carrier on it several times but it soon drifts out of null again. The
suppression on LSB I think I recall correctly is particularly poor, due to
the filter being assymetrical. Overall the rig is pretty poor on SSB. Is
there a cure, at least for the carrier null drift?
73 Fraser G4BJM
>
> Bob, this is something you could probably do yourself but not only will
>you
> need a VTVM but an RF probe and most of all the Ten Tec alignment
>process to
> null the carrier.
> I don't think TT will give out that service information.
> Could be someone on the list has it.
> And, you might find that the carrier won't null in which case another
> component has gone bad and you will need to track it down.
> Very seldom will a rig just go out of alignment all by itself unless you
> replaced something in the circuit.
> You should not go about trimming any pots before checking for that type
>of
> problem.
> Dan/N4VET
_________________________________________________________________
Find Love This New Year With match.com! http://msnuk.match.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|