| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Herc II |
| From: | "Jim G" <longpond@downeast.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 24 Dec 2006 11:40:28 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
In order to correct for erratic keying when using the Herc II with my Jupiter, I had to short out diode D1 on the control board as per instruction from Ten Tec. Now to go back to using the Paragon do I have to put D1 back in the circuit. Not difficult to do but is it necessary. Jim K1QCF _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Classic Orion optional filters, need suggestion, Arthur |
|---|---|
| Next by Date: | [TenTec] Classic Orion optional filters, need suggestion, k8vf_mark |
| Previous by Thread: | [TenTec] Classic Orion optional filters, need suggestion, Arthur |
| Next by Thread: | [TenTec] Classic Orion optional filters, need suggestion, k8vf_mark |
| Indexes: | [Date] [Thread] [Top] [All Lists] |