Carl:
I have your program. What procedure do I use to operate it with your software?
Regards,
Jack, N1BIC
At 01:57 PM 10/13/2006, you wrote:
>The rx320 interface works beautifully with BeaconSee when running the
>Jupiter with my N4PY software.
>
>Carl Moreschi N4PY
>121 Little Bell Drive
>Bell Mountain
>Hays, NC 28635
>----- Original Message -----
>From: "Jack Speer" <speerj@buck.com>
>To: <tentec@contesting.com>
>Sent: Friday, October 13, 2006 12:49 PM
>Subject: [TenTec] Jupiter - BeaconSee software
>
>
> > Has anyone successfully interfaced the BeaconSee www.coaa.co.uk
> > software with a Jupiter?
> >
> > Three choices on the BeaconSee menus seem of interest:
> > RX-320, Generic and File Interface. The author of BeaconSee wrote me
> > that most Jupiter users found File Interface most useful. None of
> > them work for me.
> >
> > Help please.
> >
> > 73,
> >
> > Jack, N1BIC
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|