Don,
It sounds like the previous owner put a piece of cardboard under the
actuator to keep it from clicking causing the relay to stay in the closed
position. Pull the cover off the relay to check it.
73,
Pat-K4BEH
On Sun, 1 Oct 2006 18:04:37 -0500 "Don and Diana Cunningham"
<wb5hak@duracom.net> writes:
> Hi again,
> On my recently acquired Omni VI+, I am experiencing problems keying
> my
> TL-922A amp. The amp has been modified so that the keying line
> requires
> sinking only 10 VDC @ 10 ma, so a relay should handle it easily! I
> have
> turned the relay on in the menu, but either "on" or "off", the line
> is keyed
> all the time. Unplugging the cable unkeys the amp, so the cable is
> not
> shorted. Cable also works fine with the Orion II. Is there
> something
> common I should look for, or is it Ten Tec service calling time?? I
> just
> don't want to overlook something obvious before calling Paul.
> Loving the
> rig so far!!
> 73,
> Don, WB5HAK
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|