On Sun, 2006-10-01 at 18:04 -0500, Don and Diana Cunningham wrote:
> Hi again,
> On my recently acquired Omni VI+, I am experiencing problems keying my
> TL-922A amp. The amp has been modified so that the keying line requires
> sinking only 10 VDC @ 10 ma, so a relay should handle it easily! I have
> turned the relay on in the menu, but either "on" or "off", the line is keyed
> all the time. Unplugging the cable unkeys the amp, so the cable is not
> shorted. Cable also works fine with the Orion II. Is there something
> common I should look for, or is it Ten Tec service calling time?? I just
> don't want to overlook something obvious before calling Paul. Loving the
> rig so far!!
> 73,
> Don, WB5HAK
>
My guess is that thee PA keying relay has been quieted with a match
stick holding it closed. Remove the match stick.
--
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|