TenTec
[Top] [All Lists]

Re: [TenTec] [Orion] V1.373b5

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] [Orion] V1.373b5
From: "Barry Gross" <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 30 Aug 2006 06:50:42 -0400
List-post: <mailto:tentec@contesting.com>
I would have ditched the spectrum scope to free up memory.

73,
Barry N1EU

On 8/29/06, Merle Bone <merlebone@charter.net> wrote:
> Duane said:
>
> "But in order to choose between the
> two levels mentioned, it would help to know what the fixes were (and even
> what broke on later 1.373b5 level, if any of that has been summarized).
>
>         73,  Duane  (for me and K5LN)
> ----------------------------------------------------------------------------------------------
> The fundemental problem with the V1 firmware (Including v1.373b5) was stated 
> by TenTec as:
>
>  "There were two major problems with the original V1 firmwarethat 
> precipitated the extensive revision.  The primary issue wasunresolved 
> failures in time-sensitive, state-driven communicationsbetween the three 
> processors on the DSP/Logic board. Each DSPprocessor had its own 
> state-machine or command sequencer. The DSPprocessors also streamed data 
> between themselves. In addition, therewas a master state-machine that managed 
> the interaction betweenprocessors, T/R operation and the user display. Any 
> loss ofsynchronization between these various entities would lead to 
> anunrecoverable system error that could be cleared only by a powercycle.      
>     Correcting the state-machines was not an option because ofthe second 
> issue. The DSPs were completely FULL. No memory wasavailable to implement any 
> fix. The V1 DSP code didn't make efficientuse of the available resources. The 
> V1 SSB/CW receiver mimicked theFILTER method of SSB demodulation instead of 
> the more code-efficientWEAVER method.
  T
>  he decision to change methods also meant discardingmost of the old code."As 
> you can see, unfortunately TenTec not only changed the control code but they 
> also redesigned most of the functions of the radio that are implemented in 
> the DSP. V1.373b5 is very stable for me if I keep the SpectrumDisplay off, 
> don't poll the Orion for frequency data and use the Voice Data Recorder 
> sparingly. It also helpsnot to use the software NB or Noise Reductio on the 
> Subreceiver.I hope this helps with questions about V1.373b5.73,Merle - W0EWM
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>