Carl Many Thanks - fixed.
73 Dave G3RXP
----- Original Message -----
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, July 25, 2006 8:23 PM
Subject: Re: [TenTec] Orion 2 and DxBase 2005
> The Orion only runs at 57600 baud, 8 bit, no parity, 1 stop bit.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message -----
> From: "G3RXP" <g3rxp@btinternet.com>
> To: <tentec@contesting.com>
> Sent: Tuesday, July 25, 2006 3:06 PM
> Subject: [TenTec] Orion 2 and DxBase 2005
>
>
>> Hello All
>>
>>
>> My DxBase 2005 logging program does not appear to have a default baud
>> rate
> for the Orion 2 and I cannot get it to talk. N1MM works OK so the physical
> link is there. Can I change the default baud rate on the Orion to match
> DxBase 2005? or visa versa?
>>
>> Many Thanks
>> Dave G3RXP
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.394 / Virus Database: 268.10.4/396 - Release Date: 24/07/2006
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|