You can't change the Orion settings, but you can change the dxbase interface
settings to 57600, 8 bit, 0 parity, 1 stop bit. I'm using dxbase 2006 now,
but 2005 worked fine with the Orion with those settings.
73,
Stan W4AG
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of G3RXP
Sent: Tuesday, July 25, 2006 3:06 PM
To: tentec@contesting.com
Subject: [TenTec] Orion 2 and DxBase 2005
Hello All
My DxBase 2005 logging program does not appear to have a default baud rate
for the Orion 2 and I cannot get it to talk. N1MM works OK so the physical
link is there. Can I change the default baud rate on the Orion to match
DxBase 2005? or visa versa?
Many Thanks
Dave G3RXP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|