I believe the connectors you are referring to are AMP MTA .100 series IDC
connectors. Mouser has a complete listing.
73,
-Lee-
On 2 Jun 2006 at 9:49, k7gt@charter.net wrote:
> I have been using the RS232 connection all along to control the Herc II and
> could use it to control bandpass filters and antennas if I only cared to
> operate on the 6 'contest' bands. But, I wish to have all three WARC bands
> incorporated into my scheme. Thus, I need those additional voltages
> separated out. Rather than attempt to add suitable voltages to the RS232
> output (I have found places inside the rig where I can find all 9 voltages)
> I would like to bring them out from the internal connector elegantly. That
> was
> the intent of my initial post: find the manufacturer of the connectors and
> hopefully an adapter that will allow me to grab the voltages.
>
> Allan K7GT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.394 / Virus Database: 268.8.1/354 - Release Date: 6/1/2006
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.8.1/354 - Release Date: 6/1/2006
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|