I have been using the RS232 connection all along to control the Herc II and
could use it to control bandpass filters and antennas if I only cared to
operate on the 6 'contest' bands. But, I wish to have all three WARC bands
incorporated into my scheme. Thus, I need those additional voltages
separated out. Rather than attempt to add suitable voltages to the RS232
output (I have found places inside the rig where I can find all 9 voltages)
I would like to bring them out from the internal connector elegantly. That was
the intent of my initial post: find the manufacturer of the connectors and
hopefully an adapter that will allow me to grab the voltages.
Allan K7GT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|