On May 28, 2006, at 5:01 PM, James Pearson wrote:
> was tuned into 500w dry load out put on external avg watt meter was
> aprox 50 watts did tune a short wave rec to same freq and tried
> different drive settings processor produces some level of hum amp draw
> on power sup aprox 18amp.
Hum? Processor? OK, turn off the processor completely, those can
really mess up the audio anyway. Put on the non amplified mike,
processor off. Keep the drive control all the way down, turn it up
until the little ALC light just barely lights on voice peaks (really!
just barely lights when you shout!) Then listen on the external
receiver. See if it improves at all. Note any changes in how it
sounds. Hum on SSB peaks can be the power supply caps sagging when the
draw goes up quickly. Do you have another power supply to substitute?
Do you have a car battery to substitute for the power supply for a
temporary test? That can be helpful.
WA3JPG
Clark Savage Turner, J.D., Ph.D.
Professor of Computer Science
Cal Poly State University
San Luis Obispo, CA. 93407
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|