TenTec
[Top] [All Lists]

Re: [TenTec] RF in Audio Mods for Jupiter

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] RF in Audio Mods for Jupiter
From: "Larry Menzel" <retire@means.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 28 May 2006 14:28:28 -0500
List-post: <mailto:tentec@contesting.com>
I agree, and I suspect you are suffering from some version of "common mode" rf interference.

I suggest:
1. Make sure your coax does not run in close proximity to your AC lines in the shack if possible. 2. Make sure if you have other runs of coaxial cable that they're not bundled together close to the radio. 3. Do you have an antenna rotator? Make sure that line is not running directly next to your coax. A couple of turns on a large doughnut torroid on the rotator line can be very helpful in breaking common mode interference. 4. Where your coax enters the shack, form a coaxial balun, about 6-8 turns on an 8" diameter and tape or tiewrap it in place. This will help keep rf off your coax as well. 5. Make sure your amp and all radios and power supplies are grounded with separate ground straps to a common tie point and thence to a good earth ground...not cold water pipes or electrical system ground. Coax braid works great.

You should not have any difficulty running a kw with your Jupiter or any other radio for that matter. I have two amps in the shack one on each Orion, and run them at 1500 watts out all the time during two radio contests without any rfi or rf in my radios.

Good luck.

Larry, N0XB
Northfield, MN


----- Original Message ----- From: "Jim" <pywacker@fuse.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Saturday, May 27, 2006 10:19 AM
Subject: Re: [TenTec] RF in Audio Mods for Jupiter


For what it is worth I always find that I have to be more careful of
grounding & ground loops and much pay more attention to shielding and place
several cores on cabling.

Jim


-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Lyle Dunlap
Sent: Saturday, May 27, 2006 8:50 AM
To: n9vx@myway.com; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] RF in Audio Mods for Jupiter

To N9VX

Are you sure its not your ant. system? I had a Jup for a while ran it into
a KW with no RF problems.

Lyle W9FCX


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>