| To: | "Paul Gates, KD3JF" <pearly732003@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] usb to serial |
| From: | Ed <w3nr@comcast.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 17 May 2006 17:56:55 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
Paul Gates, KD3JF wrote: I have the WMR cable and cd with the drivers. Alot of the cables sold will work if you have the needed drivers for it to work. If you get the WMR one be sure you install the drivers before you plug in the cable to the USB port.Paul, KD3JFGlen Burnie, MD FM19qd (Map Grid Square) I've been following this thread. The exact same IOgear cable is available from Walmart for $25, and their 4 port hub is under $10. Works perfectly under XP for rig control and digi modes, and AFSK RTTY. Using Linux no drivers are required, just plug and play. Ed W3NR |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Ten-Tec at Dayton, W9efl |
|---|---|
| Next by Date: | [TenTec] Idle current of O2 in receive mode, Frederick M. Mott |
| Previous by Thread: | Re: [TenTec] usb to serial, Paul Gates, KD3JF |
| Next by Thread: | Re: [TenTec] usb to serial, K4IA |
| Indexes: | [Date] [Thread] [Top] [All Lists] |