I, too, have thought of the bracket idea for adding an RF gain pot. At
one time I rewired the mic gain pot for this but I took the mod out,
because I didn't want a non-standard Scout.
Why use an external pot at all? Just epoxy a shaft extension on to the
existing pot and put a miniature knob on the bottom where the shaft
extension comes through the hole.
A pot could be placed on the back without drilling, but this would
require giving up the FWD/REF switch or one of the key jacks.
73,
Bob WB2VUF
Stuart Rohre wrote:
> The only problem is how you attach the external pot.
> I thought a good solution would be to add a bracket for it under the bail/
> foot at the front, and bring the pot out to front panel area that way.
> However, I do not operate at various powers enough to have prompted me to
> add it that way. I was going to use flat cable out the back for the wires.
> One issue was should they be shielded? Probably a quick mock up would show
> if there is RF leakage with longer wires.
> 73,
> Stuart
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|