I have read most of the posted modifications for easy access to the RF power
control from an external pot on the back to using the mic gain pot. Have any
gone with a small pot mounted on the bottom of the chassis below the present
access hole for the board mounted RF pot? It just seemed this would give
access and maintain the originality of the SCOUT. The reason I ask is that this
sounds too practical and there must be a reason it is not/has not been a
recommended method.
Alan KB7MBI
Woodinville, WA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|