Your email address, Paul? It is not listed in QRZ.com
Diode might be jumpered because it is open? I have a few BA542 to spare.
You can call Ten-Tec and get some sent to you very easily, and very
inexpensively.
They sent me a dozen for free.
Don, VE1BN
----- Original Message -----
From: "Paul Sojka" <lunenburg@peoplepc.com>
To: <tentec@contesting.com>; <TenTec@yahoogroups.com>
Sent: Saturday, April 15, 2006 1:52 PM
Subject: [TenTec] (no subject)
> I've lost sensitivity on the 6.5 - 10.5 section of the Paragon 585. It's
> happened
> a few times before and was cured by replacing Diode D12, a 1N4148, on the
> RX high pass filter
> board. It didn't work this time. I swapped diode D5 with one on the same
> board and
> it still did not work. I jumpered D5 with a wire and it works. The diode
> is a type
> BA482 which I cannot find. Any ideas why it works jumpered? Anyone have a
> source
> of this type diode aside from Ten Tec? I'd like to buy a few. The 1N4148's
> are in
> Radio Shack so no problem there. Thanks,
> Paul
> KS2S
>
>
> ________________________________________
> PeoplePC Online
> A better way to Internet
> http://www.peoplepc.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|