Thanks carl...I really never got a chance to demo it due to school and work
so I guess I will just purchase it.
As far as the responce using logic8. Do you really should work for them.
Personally, it's a fat program and costs too damn much!
On 4/16/06, Carl Moreschi <n4py@arrl.net> wrote:
>
> If you run my N4PY Orion software in combination with MixW, all is well.
> MixW can be configured to work with my software and the OII in complete
> harmony.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message -----
> From: "Douglas Shock" <douglas.shock@gmail.com>
> To: <TenTec@contesting.com>
> Sent: Sunday, April 16, 2006 5:29 PM
> Subject: [TenTec] Orion II and MixW cat issues
>
>
> > Anyone experiancing issues with mixw and the Orion II performance when
> > servicing interupts and using the cat interface from MixW?
> >
> > The only speed I can get anything to work at is 57600, but at this baud
> > rate, the perfornace of the Orion II sweep is at a standstill and I have
> to
> > push buttons 3 to 4 times to get the Orion II to respond.
> >
> > When I change bands from within MiXw I can hear the radio change but the
> > freq. readout doesn;t change.
> >
> > Any Ideas?
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|