Carl,
I've checked very carefully on my ORION II and there is 4 hertz of
difference between the Sub Receiver and Main Receiver at 15.0 MHz. This
might give a very mild reverb effect on a music note... But I can not
really observe it at all, unless I listen to the CW offset to get a pure
note. I'm not sure if I'm perfectionist enough to make an adjustment to
align these two receivers to this level or not. Maybe on a steady carrier
would warble enough that I would want to.
But it would be nice to have it as a feature in the N4PY software.
Ron
KA7U
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Carl Moreschi
Sent: Wednesday, April 12, 2006 5:17 PM
To: tentec
Subject: [TenTec] Orion Main and Sub frequency difference
Bill,
I don't know why I never thought of this before but I have a diversity mode
in my N4PY Orion program. It sets the two radios to the same frequency as
you tune
with the remote tuning pod. I can easily put in a user configurable
frequency difference in my program to handle a few hertz offset. I am going
to add this to the next version of my program. Thanks for the idea.
73,
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|