Yes, I have a full software frequency calibration routine.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Ron Castro" <ronc@sonic.net>
To: "Carl Moreschi" <n4py@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Wednesday, April 12, 2006 8:58 PM
Subject: Re: [TenTec] Orion Main and Sub frequency difference
> Do you also have a calibration offset for the main oscillator?
>
> Ron N6AHA
>
> ----- Original Message -----
> From: "Carl Moreschi" <n4py@arrl.net>
> To: "tentec" <tentec@contesting.com>
> Sent: Wednesday, April 12, 2006 4:17 PM
> Subject: [TenTec] Orion Main and Sub frequency difference
>
>
> >
> > Bill,
> >
> > I don't know why I never thought of this before but I have a diversity
> > mode
> > in my N4PY Orion program. It sets the two radios to the same frequency
as
> > you tune
> > with the remote tuning pod. I can easily put in a user configurable
> > frequency difference in my program to handle a few hertz offset. I am
> > going
> > to add this to the next version of my program. Thanks for the idea.
> >
> > 73,
> >
> > Carl Moreschi N4PY
> > 121 Little Bell Drive
> > Bell Mountain
> > Hays, NC 28635
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|