the vee beam isn't rated for qro.
73,
Mike N4NT
----- Original Message -----
From: "Dave Tipton" <dave@lodave.org>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, April 04, 2006 11:04 AM
Subject: [TenTec] Vee Beam
> Anyone here actually using the Vee Beam that is being offered on TenTec's
> site? I see that B&W also offers an end fed version that is similar.
> Just curious to see if anyone has an opinion about the design. :)
>
> After watching my push up mast snap this weekend, about 4 feet below the
> thing would have been guyed, and my MA5B taking a header into the ground,
> I'm searching for slighly less wind load options for now until I decide
> about putting a tower up. Great pictures of the event are available at
> http://blog.360.yahoo.com/blog-Dse6wvI1aaLHpzblehQs0wQ-?cq=1&p=32
>
>
> Dave, W3DMT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|