Phil,
It does this here too. Both receiver A or B. The hardware noise blanker
seems to work correctly with these settings so that might be a work around
for your situation.
Ron
KA7U
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of AI4DQ@aol.com
Sent: Sunday, April 02, 2006 12:07 PM
To: tentec@contesting.com
Subject: [TenTec] Problem: Please confirm Orion II Radios
Version 2.032 software
When operating my new Orion II this am Had terrible Noise with NB set to 2
,
NR 3, Notch on and the SP set 3 and sweep on I then went notch C position
rotating the Down from 1000HZ when I get past 900HZ I lose audio and is
replaced with crackling sound The only way to restore the audio is by
turning the
radio off and on a reset is not required. I would like others to confirm,
And I have one other owner confirm(WB4QDA) this Bug. and would like
everyone to
confirm this. I tried others setting but the NB has to be on and the NR has
to be on as well as Notch.
Phil AI4DQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|