Hi Danny,
I think you should crank the voltage up to the rated 13.9V.
I'm not familar with the 262G supply but I assume it's like most
others in that is has a voltage adjustment pot inside. Set it for
13.9 volts with only the receiver for a load. A drop of .75v is
not too bad at full power but the overall voltage is too low.
73 Jim k4CGY
--- Danny Shaver <n5nbk@nortexinfo.net> wrote:
> Hello Ten-tec techies, I need some help!!
> I have a 262G power supply that I just got with a Triton IV.
> I am getting distorted SSB transmit reports when I turn the ALC
> up all the way on all bands. It is fine when I put the ALC at
> about 50%.
> The voltage out of the supply is 12.95 volts on receive. In
> transmit with 50% ALC it drops to 12.5 to 12.67 volts, and at
> 100% ALC it goes to 12.24 to 12.35, depending on band. I am
> testing into a 50 ohm dummy load. What do you think?? Thank you
> for your help in advance.
>
> Dan N5NBK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|