>From my own personal experience (your milage may vary) I have used the
recommended Airpax circut breakers in the past with a homebrew power supply,
and have had to send my Omni 6 back 3 times to have the finals and driver
transistors replaced. It wasn't until I procured a TT 961 power supply that
matches the rig that I had some real protection. The Airpax circut breaker,
in my case, was not fast enough acting to protect the rig. Both my Paragon
II and Omni 6 now have separate 961 power supplies.
And no more fried finals....
----- Original Message -----
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Friday, January 20, 2006 6:40 PM
Subject: Re: [TenTec] Paragon Problem - Solved
> Buy a Ten Tec supply or go with an Astron and an Airpax breaker in the
> positive line to the rig.
> Junk the one you have.
> It could fry the finals on that fine Paragon if you try to tune up with
> it.
> I would never ever use it without an Airpax breaker in line even if it was
> working FB.
> Dan/N4VET
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|