In my case the Omni VI Plus is connected to the computer directly without
any interface, transformers or level shifting devices. With that said, the
sound card in the computer supplies both LINE INPUT and LINE OUTPUT levels.
Most have only Mic input and speaker output levels. These won't work
without some level attenuation methods.
With the sound card supplying Line In and Line Out levels, connect direct to
the RCA jacks on the back of the Omni being Audio In and Audio Out. Adjust
levels on the Sound Card mixer as needed. The VOX gain on the Omni is at 15
and the VOX delay at zero and the front panel MIC level control runs at
about 9 o'clock. Be sure the PROCESSOR is not active. Using Mix-W as
software, choose the mode of your choice and enjoy digital contacts.
I've used this method for years very successfully and with excellent
reports.
73
Bob, K4TAX
----- Original Message -----
From: "Keith Bainbridge" <vk6xh@arach.net.au>
To: <tentec@contesting.com>
Sent: Thursday, January 12, 2006 6:43 AM
Subject: [TenTec] RTTY on the Omni VI
> Can anyone offer a bit of basic advice on rtty connections and operation
> with the Omni 6 please.
> The limited amount of digital stuff I've played with over the past 25
> years has always been through rigblaster interfaces and I believe the
> Omni 6 has the right connections to do without one for rtty and other
> digital modes.
> I note there is audio in , audio out and mark/space rca's on the back of
> the rig, but the info in the manual is somewhat lacking compared to the
> FT 920 and soundcard I was using at the last attempt.
> I've used various programs including mixw2 and mmtty amongst others,
> But a bit of guidance wouldn't go amiss.
> I'm not a digi mode sort of operator, SSB is my first love ( sacrilege
> I hear most of you say ) but would love to have a play !!
> I have an Omni VI opt3 and an Omni D series B
> Replies off list would be fine.
> Mni tnx
> Keith VK6XH vk6xh@amsat.org
>
> --
> Keith Bainbridge
> VK6XH & VK6DXR
> President, Northern Corridor Radio Group. ( VK6ANC )
> Amsat NA #35338
> Wireless Institute of Australia. #307254
>
> Former Calls include:
> G6HHV, G0HEI, G1GHZ, VK6BRK, VK6DXC & VK6AHH
>
> You're just jealous because the voices only talk to me !!
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|