I was cleaning around the shack and had the 12 VDC power removed from my
Paragon 585 (not a Paragon II) for an hour or so. When I hooked it back
up and turned on the 585, the controls are not working and the display
is not there. I have tried the RESET button on the right hand side of
the rig, and this does not fix it. I have not yet opened it up and
checked the voltage of the 9V NiCad memory battery. It has been
connected to 12 VDC power for a day now, and I would expect that battery
to have recharged by now. If that battery is dead will the radio not
work, or will there just be no memory when the radio is powered off? Are
there any other reset methods I need to try? Hold a certain button while
powering up?
Thanks DE N6KB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|