I am using the Microham band decoder with both my Orion and Elecraft K2. It
can output the appropriate signal to auto-switch my Icom pw1 (it works
really well). I believe they also sell a plug that would provide the
appropriate output to control a quadra. Check out their website
http://www.microham-usa.com/Products/band%20decoder.html.
I am very impressed with everything they make.
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Richard Cardwell
Sent: Monday, September 05, 2005 12:08 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] ORION with Yaesu Quadra amp?
Rick
I thing Top Ten Devices makes an interface that should fit your needs. The
link is:
http://www.qth.com/topten/
At least I hope so as that is the interface I am planning to use.
Rich, AA2BY
----- Original Message -----
From: "NJ0IP" <Rick@DJ0IP.de>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Sunday, September 04, 2005 4:00 PM
Subject: [TenTec] ORION with Yaesu Quadra amp?
>A question for the experts:
>
>
>
> Does anyone make level converter that will allow the Orion to control a
> Yaesu Quadra amplifier?
>
>
>
> Appreciate any tips.
>
>
>
> Tnx
>
>
>
> 73
>
> Rick
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|